ABS entlüften RAM 05

Dodge-Forum

Help Support Dodge-Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Registriert
13. Nov. 2015
Beiträge
28
Reaktionspunkte
0
Ort
BERLIN
Moin,
kann der ABS Block auf herkömmliche Art und Weise entlüftet werden (egal ob von unten nach oben oder mit Vakuum oder wie auch immer) oder muss der ABS Block angesteuert werden um die Luft da rauszubekommen?

Grüsse
Andy
 
Entlüftet wird eigentlich mit der herkömmlichen Methode. Zusätzlich wird aber dann (laut Manual) per OBD und Scantool, die ABS-Pumpe angesteuert um diese auch zu entlüften.

ABS BRAKE BLEEDING
ABS system bleeding requires conventional bleeding methods plus use of the DRB scan tool. The procedure
involves performing a base brake bleeding, followed by use of the scan tool to cycle and bleed the HCU pump and
solenoids. A second base brake bleeding procedure is then required to remove any air remaining in the system.
1. Perform base brake bleeding, (Refer to 5 - BRAKES - STANDARD PROCEDURE) OR (Refer to 5 - BRAKES -
STANDARD PROCEDURE).
2. Connect scan tool to the Data Link Connector.
3. Select ANTILOCK BRAKES, followed by MISCELLANEOUS, then ABS BRAKES. Follow the instructions displayed.
When scan tool displays TEST COMPLETE, disconnect scan tool and proceed.
4. Perform base brake bleeding a second time, (Refer to 5 - BRAKES - STANDARD PROCEDURE) OR (Refer to
5 - BRAKES - STANDARD PROCEDURE).
5. Top off master cylinder fluid level and verify proper brake operation before moving vehicle.
 
Oben